Router CAMEO Default Login - Username, Password and IP Address

Detected IP Address For CAMEO Login Admin

Based on your local IP address, this should be your router admin IP address. This is only the case if you are in the same network as your wifi router.

How to access CAMEO router

A stronger network is desired with the increasing number of internet devices and Cameo routers are one which are providing a solution to this.

Every Cameo router has an IP and username/password combination which can be looked into the user manual received. If not found there, you can take the support from the below guide.

Steps to the login of CAMEO router to access setup

To access the Cameo router services, you must be first connected to it. Hence connect your computer/laptop connected to the router.

Using a wired connection is recommended so that the router loses its power, then data is not lost.

Once connected, following the below process will assist you to the login interface.

  1. Use a web browser that is available with you (Chrome, Firefox or Internet Explorer).
  2. Type the IP in the address bar of the web browser.

The default IP address of a CAMEO router is You can also look for the correct IP at the router’s backside printed.

  1. Mention the Username and Password in the login page.

You can try the default values if you are a first time user or use the credentials available with you. The default username and password are admin.

  1. You will be guided to the router’s web interface of the settings section. Yu can now make the modifications in the router defaults as per your requirement.

Recommendation: The default settings must be noted by a user before changing them for future usage.

What to do if your router stops working after changing configuration

Cameo Router defaults list

The very basic requirement to locate the router settings is the IP address. Below list represents a list of IPs that can be used to get to the login user interface.


CAMEO router troubleshooting

Using the above default IP, login page can be accessed but further correct username and password is also required. This details are printed on the router’s bottom or backside.

When they even cannot provide you the login access, then you need to reset the router. A reset button is available on the router that needs to be pressed and hold for 30 seconds which will set the router settings to the defaults.

Resetting might end the connection link. Hence, always keep a record of the default settings before amending any changes in it.


To reset the router must be the last option. However, if you can log in and revert the settings with the previously noted defaults, it should be done at first level. You can also seek some expert advice if needed.