Router CenturyLink Default Login - Username, Password and IP Address

Detected IP Address For CenturyLink Login Admin

Based on your local IP address, this should be your router admin IP address. This is only the case if you are in the same network as your wifi router.

How to access CenturyLink router

Better connectivity and superior customer experience through the latest technology are what a CenturyLink router aims. To provide all such customer experience, a CenturyLink router is provided with a unique Username/Password Set and an IP address to its web setup console.

A user can go through the small user guide below for quick access.

Login process of CenturyLink router

A computer system with a web browser installed and an Internet connection is a must to login into the router settings.

With the above requirements fulfilled, the below steps will grant you the login access.

  1. Get a wired or wireless network established to your device with the router.

Recommended: In case of any power shortage, the router must not disconnect, hence use a wired network.

  1. Navigate using a web browser to the IP

By using any of the available web browsers get to the login user interface of the router. The default IP for a CenturyLink router is

  1. Router’s admin panel can now be accessed where you need to specify the set username and password.

You must specify the set credentials or else use the default username as blank and password as 1234 if you are a new user.

  1. A successful login with guide you to the routers control panel with all the settings stored.

Note: Before changing the settings make sure to note all the default values with you.

What to do if your router stops working after changing configuration

CenturyLink router troubleshooting

The login access to the router admin panel can be denied when a wrong user credential or an incorrect IP is used. The correct details can be found over the router’s base or backside printer on a sticker. But if the router misses this, then try to find the correct details.

The final troubleshooting when all the above has failed is to reset the router. Doing this will set the router to its default settings but this may tend to break the communication link. Hence you must keep a record of all the previously set default values.

Resetting can be performed by pressing the reset key present at the router’s base for 30 seconds.

Now you can try login again using the default credentials mentioned above.


Before applying the reset option, a user must find a way to revert the settings to the default with prior knowledge of them as a primary solution. Also, try to seek expert advice for a solid solution for your problem.

Models using CenturyLink