Detected IP Address For Edge Core
| 192.168.2.1 | Login Admin |
Based on your local IP address, this should be your router admin IP address. This is only the case if you are in the same network as your wifi router.
How to access Edge Core router
In this fast-moving and always craving world for online data access, Edge-Core router focus on how the world connects. A converged and scalable network can be formed using an IP and a Username/Password combination by first reaching the system admin panel of the router. The bellow short article will help in gaining the login access for your router.
An Edge-Core router Sign-in process
If you want to make your router’s network safe and secure, then you need to first login to the admin page to access the security settings. The below steps will guide you on this.
- Setup a connection of your network device with the router using a Wi-Fi or an Ethernet cable. It is recommended to have a wired connection to prevent losing the connection in between.
- Guide yourself to the login interface by mentioning the default IP of your router in the address bar of any available web browser.
Your Edge-Core router has a default IP address 192.168.2.1. You can use this to reach the Sign-in page.
- Now, you can use the default login credentials to get to the control page of your router. Every Edge-Core router can be accessed using the default username and password both as admin.
- You will now have access to the control page of the router where all the settings are saved and can be modified as well.
Note: Before making the changes to the settings it is recommended to jot down all the default values well in advance for future use.
What to do if your router stops working after changing configuration
Troubleshooting you router
The functioning of your router can be affected due to many reasons such as when you made to many changes in the settings or you forget the login credentials. If such happens, then you can resume the router services by a simple reset option.
Find the reset key on the bottom of the router and use a pin or toothpick to press it and hold for 30 seconds. This will bring the router to the factory settings again. Yet this might end the connection sometimes hence should be opted as a last possible solution.
Get Connected
To be able to get yourself connected to the router and check its security settings, a user must have a valid set of IP address and login credentials.
Such information can be well located on the router itself. Look for a small tag at the bottom or backside which has the default data for your router. But, if the route does not have that tag on it, then refer to the above-stated ones.
Conclusion
Every Edge-Core router is specified some default user pass keys and it will be a sensible decision to update them regularly to protect the network. Take the help from this annual on how to amend the changes.