Detected IP Address For Microlink
| 192.168.1.1 | Login Admin |
Based on your local IP address, this should be your router admin IP address. This is only the case if you are in the same network as your wifi router.
How to access Microlink router
There has been a tremendous amount of improvements in wireless and wired communication technology. As expected, your Microlink router offers blazing speed with multi-device connectivity, all at affordable pricing. For a user with several connecting devices or a huge house, a Microlink router is an obvious choice. All you require is an admin Username and Password to get connected.
Login steps to your Microlink Router
Gaze upon the below steps to login and then configure your router.
Step 1: Join a wired or Wi-Fi connection with your Microlink route to begin the process.
Step 2: Open a pre-installed web browser and type the default IP address stated on the router's backside. If not found, then contact the brand with your router's model and make information.
Step 3: To login, mention the Username and Password on the web page that appears. Your default Username is Admin and Password is password.
Step 4: If you have given the privilege to set the user credentials, present some inconstant values.
Step 5: The control panel of your Microlink router will open.
In addition to this, make a note of the existing settings in advance. You can revert at any point in time henceforth.
What to do if your router stops working after changing configuration
Troubleshooting
When you struggle to reach the control setup of the router, then you might be presenting some incorrect login value. Your router's functioning might be affected as well due to this. Hence, to resume proper service access, reset the router to install the factory values again. The process of this is as follows.
- Turn your router off and press the reset key on the bottom of the router.
- Use a toothpick or Pin for pressing the button. You must be pressing for approximately 20-30 seconds.
- As soon as the LEDs stop blinking and become stable, turn the router On to finish the reset.
Getting Connected
Your router's connectivity is dependent on a correct set of user details and IP. Once you alter these values, you decide the functioning of your router. Hence, it is sensible to note all the formulations that you made. When somehow you cannot connect to your router, then look at the bottom to find the default username/password and the IP address. You can also find this information in the user manual produced with the router.
Conclusion
A smart and powerful package that offers internet services is your router and hence must be protected from trespassing activities. Always find ways to get into the control setup of it and update the security and profile data. When in doubt, find help within the guide or with an expert.