Detected IP Address For Paradigm
| 192.168.1.1 | Login Admin |
Based on your local IP address, this should be your router admin IP address. This is only the case if you are in the same network as your wifi router.
How to access Paradigm router
There has been a constant enhancement to communication technology for both wired or Wi-Fi networks. As exacted, your Paradigm router offers speedy performance with multi-device connectivity, yet affordable pricing. For a user with several connecting devices or a huge house, a Paradigm router is an obvious choice. Gather the admin Username and Password to get connected.
Login steps to your Paradigm Router
Scrutinize the below steps to login and then configure your router.
Step 1: Register a wired or Wi-Fi connection with your Paradigm route to begin the process.
Step 2: Commence a pre-installed web browser and keyboard the default IP address stated on the router's backside. If not found, then use 192.168.1.1 as the default gateway.
Step 3: To login, mention the Username and Password on the web page that appears. Keep your default Username and Password as admin.
Step 4: If you are allowed to set the user credentials, present some inconstant values.
Step 5: The control panel of your Paradigm router will open.
In addition to this, make a note of the existing settings in advance. You can revert at any point in time henceforth.
What to do if your router stops working after changing configuration
Troubleshooting
When you struggle to reach the control setup of the router, then you might be presenting some incorrect login value. Your router's functioning might be affected as well due to this. Hence, reset the router to install the factory values again and resume proper service access. The process of this is as follows.
- Turn your router off and press the reset key on the bottom of the router.
- Use a toothpick or Pin for pressing the button. You must be pressing for approximately 20-30 seconds.
- As soon as the LEDs stop blinking and become stable, turn the router On to finish the reset.
Getting Connected
An exact assembly of user details and IP defines your router's connectivity. Once you reconstruct these values, you decide the functioning of your router. Hence, it is sensible to note all the adjustments that you made. When anyhow, you cannot connect to your router, then look at the bottom to find the default username/password and the IP address. You can also find this information in the user manual produced with the router.
Conclusion
A smart and powerful package that connects you with the ISP is your router and hence must be protected from trespassing pursuits. Always find ways to get into the control setup of it and update the security and profile data.