Router Pirelli Default Login - Username, Password and IP Address

Detected IP Address For Pirelli

192.168.1.1 Login Admin

Based on your local IP address, this should be your router admin IP address. This is only the case if you are in the same network as your wifi router.

How to access Pirelli router

Your Pirelli router (example DRG A125G) can be accessed using an IP address and a Username/Password combination. A user can eye the handbook presented for all these details. However, a user missing manual can take help with the below article.

Login Steps

With uniquely specified user credentials and an IP address, every network device pairing is possible with your HP router. Swiftly glide through the below steps for your admin access and network installation.

Step 1: To begin, form a connection, either wired or wireless. Ensure that your computer and the router are connected.

Step 2: Once the devices are connected, state the default IP 192.168.1.1.

Step 3: Now, specify the username and password on the login page to access the control panel web interface. If you are unaware of what to use, then follow this article below.

Step 4: With possible combinations, you will see your router's admin panel and so, make adjustments to the settings as required.

Note: Eventually, copy all the factory-made settings in advance once you reach the admin panel.

What to do if your router stops working after changing configuration

Troubleshooting

If using the default is not granting you the login to the router, or somehow you forgot your user passkey, then the final remedy to your problem is to reset the router. It is a simple process. Turn around your router and locate a reset button. Then, press it for approximately 30 seconds for a hard reset that will set all the factory values. However, this might end up terminating the link sometimes, and hence this should be our last call for a solution.

However, when a user can log in to the control panel, then a solution to all the router issues is to reefed default settings manually.

Getting Connected

You require an IP address and User credentials to reach the admin panel of your HP router. But, if you are not interested in looking into the user book, then try some standard combinations listed below.

Username: admin, 3play, user, on, telecom, cytauser

Password: admin, microbusiness, 3play, user, on, telecom, cytauser

You can also look at your router's base or rear side for these details.

Conclusion

Strong login credentials are required to set up and operate your Pirelli router's network. Also, to fix any reported issue, always login to the router's admin and revert the settings with prior knowledge of them. Peek through the user manual or look into this guide for any assistance.

Models using Pirelli