Router Thomson Default Login - Username, Password and IP Address

Detected IP Address For Thomson

192.168.0.1 Login Admin
192.168.1.254 Login Admin

Based on your local IP address, this should be your router admin IP address. This is only the case if you are in the same network as your wifi router.

How to access Thomson router

A Thomson router stands out to be an ideal router in providing all the solutions to home and office networks. A user is also provided with the user manual with the router that contains all the information about your router in it. To reach the web user interface of any Thomson router we require an IP and Username/Password to login. The below small guide can help with such a process.

Login Process to your Thomson router

To improve your network security or to solve any connection issue with regards to your Thomson router, you must access the admin panel in the first place.

Gaze upon the below process now.

  1. Set up a communication bond between the router and your device.
  2. Open any installed web browser and steer to the login web interface by copy-pasting the default IP address 192.168.0.1 in the address bar.
  3. At the login page, using the standard username and password will allow admin access. Your default credentials are listed below.

Username: admin

Password: Administrator, (keep it blank)

  1. Next, you will access the admin panel of your Thomson router with all the saved settings.

Keep in mind to save all the default settings and also your login details before changing them. So that you can refer them in the future when required.

What to do if your router stops working after changing configuration

Troubleshooting your router

You must find ways to resume the router functioning whenever the router services are interrupted. A first attempt would be to access the control settings and replace the values with previously saved ones. Although, when accessing the router's web interface is not possible due to a denied login, then use the reset button.

Press and hold for 30 seconds to apply all the factory default settings to your router. Then finally, turn the router off and on to finish off the process.

Now, using the default credentials aforementioned will grant admin access.

However, a reset must be a final ground operation as it may turn your link down.

Getting Connected

A single setup to the network is enough to collaborate with several devices whenever needed. All you require is the gateway address to be located correctly. Your user manual has all the necessary information with itself. You can also try out some default IPs listed below.

  1. 192.168.0.1
  2. 192.1686.1.254

However, if the user has not received it or does not wish to go through the entire booklet, then look beneath your router's surface for this data.

Conclusion

Setting up your Thomson router is a fun and easy task but, a user must consider not to alter the settings too often as well. Just an update to the user passkey should be enough to secure the connection.