Router VisionNet Default Login - Username, Password and IP Address

The device that assists the movement of data in the network is what a router is, and it requires two components, a local IP address, and some Username/Password combinations. Any VisionNet router can also be accessed using its credentials. A user can see these essentials in the user manual obtained with the router but, if locating these details is getting tough for a user, then he can get help from this miniature guide below.

VisionNet login methods

Your VisionNet router settings can be examined and modified only after login. Hence follow bellow steps.

1. Connect to the router's network using an Ethernet cable (recommended) or Wi-Fi.
2. State 192.168.1.2 in the web browser available with you and hit the Enter key.
3. The IP will take you to the web page with two fields as a username and password.
4. Fill the assigned fields with the desired information and click Login/Enter.
5. You must enter the login details offered to you with the router. If you have previously changed them, then specify those details.

All the control settings will open where you can make the settings as your needs.

Note: Keep in mind that the default settings of the router shall be written somewhere before making any changes, so it to replace them when required.

Troubleshooting

If all pronounced overhead has failed login access to the admin section, then the final resolution for this could be to reset the router.

Quickly achieve this by using the generic 30 30 30 hard reset mechanism. Your router has a reset pin at its backside.

However, before executing a reset, make sure to record all the default values well in advance so that, in any case, you can get back to the source settings if required. Your internet link might get suspended after a reset hence not prescribed.

Getting Connected

Using an incorrect IP address or login credentials will not find the admin login to your QTECH router. Managing such concerns requires the use of default credentials or else see the router specifications beneath the router or at its side. However, if they are missing there, then use some of the alternate options stated below.

Username: admin, enduser

Password: visionnet, password

You can try using bellow IPs to reach the router web user interface.

1. 10.0.0.1
2. 10.0.0.2
3. 192.168.1.254

Conclusion

Lower the expenses of your Internet services by getting your router separately. Always remember, with your VisionNet router, a reset should be the final available and chosen solution for any use.

• M505+