Router Zinwell Default Login - Username, Password and IP Address

Detected IP Address For Zinwell

192.168.1.1 Login Admin

Based on your local IP address, this should be your router admin IP address. This is only the case if you are in the same network as your wifi router.

How to access Zinwell router

With features like multiple device connectivity, super-fast download, as well as upload speeds and hassle-free installation process, a Zinwell router offers a Wi-Fi and broadband right at your doorsteps. Zinwell router can interconnect with every other network device with some elementary requirements, such as a Username/Password and an IP address.

Zinwell router login method

To configure the settings of the Zinwell router, follow the below steps to log in.

  1. Connect the system with the router cable or use a Wi-Fi connection.
  2. Open a web browser and type 192.168.1.1 in the address bar of it.
  3. A user interface with 2 separates areas will appear stated Username and Password.
  4. Type in the provided username and password in the desired fields and press Enter/log in button.
  5. A new window will open that is the control panel of your router.

All your Zinwell routers network and profile settings are here, and a user can modify them as per the needs.

What to do if your router stops working after changing configuration

Zinwell router Troubleshooting

Even after doing all the above steps, you find difficulty in getting through the router's control panel interface? Then, there might be another solution to this as well. You can always reset the device, and it is an uncomplex process to do. Your device has a reset button at the back of it. Press and hold that button for 30 seconds, and your router will be set back to the factory defaults. Keep in mind that after doing this, your internet connection will end. Henceforth, maintain the previously set data with you before you make the changes so that if anything goes wrong, you can get back to the start.

Getting Connected

Every router has a gateway to be located first to get a connection established. Where to get this? Well, the bottom end of your router has a sticker pasted with the default user credentials and the IP address mentioned over it. You can also trace the same from the user manual.

 

A bunch of different IPs can also workout to get to the login user interface of any Zinwell router.

a) 192.168.2.253
b) 192.168.1.2
c) 10.10.10.253

Conclusion

Usually, to reset the router should be the final remedy of the problem. However, the user can get into the control panel through login access, and then you must revert the settings as to original through prior knowledge or else get in touch with an expert to do so.

Models using Zinwell