Router ZIO Default Login - Username, Password and IP Address

Detected IP Address For ZIO

192.168.10.1 Login Admin
192.168.0.1 Login Admin

Based on your local IP address, this should be your router admin IP address. This is only the case if you are in the same network as your wifi router.

How to access ZIO router

A router is a machine that assists a user in connecting to all the web devices to an ISP. All the data has to pass through it and hence act as a vital element. To gain access to any of the ZIO router, a user must hold its Username/Password and a valid IP address. This information can be well equipped within the user manual. However, if a user didn't want to read the manual for login info, then the below guide would certainly be helpful.

Login steps to access setup

You must have some basic requirements, such as a ZIO router, an internet connection, and a web browser to start.

For any adjustments in the system, you first need to login to the ZIO routers and hence get into the control panel.

  1. Get your system connected to the ZIO router either wirelessly or through an Ethernet cable.
  2. Launch a web browser navigate to 192.168.10.1
  3. In the ZIO router login web page, enter the username/password and hit the enter key or log in.
  4. You will glide through the control panel page of your ZIO router, where you can make the desired changes.

What to do if your router stops working after changing configuration

ZIO router Troubleshooting

The best possible solutions are all mentioned above. But at last, you need to reset the modem if you are unable to connect. The best way to do it is by pressing the reset button located at the backside of the modem for approximately 30 seconds. You can even use a toothpick for that. With this, your router will reset to the factory settings. Consider the fact that after doing this, your connection will terminate as well, hence it is always recommended to seek expert advice at any point needed. Note: if you lack information in this regard, then we suggest you get guidance from a knowledgeable individual.

Getting Connected

Every ZIO router has an IP address and a Username and Password, but if a user is unaware of it then, the below list would help to gain access into the control panel settings.

Username: admin

Password: 123456789

An IP address is also essential to reach the admin login, which the brand states over the router bottom or side section. Although a user can also try some alternate IP addresses if the router doesn't have the same over it.

  1. 192.168.10.1
  2. 192.168.0.1

Conclusion

Typically you can opt for this as a final troubleshooting option if you cannot have access to the ZIO router. But, then you must always login and revert to the settings first if you still have login access.